Unity Resin Premium Coating & Casting Epoxy Resin- 1 Gallon Kit

Please make sure to follow the instructions below as precisely as possible to get optimal results, and to help avoid your finished product from not curing properly. When working with any resin, always be sure to follow recommended safety guidelines and information, work in a well-ventilated area, and wear proper protective gear including a respirator mask, gloves and eyewear. The ideal working temperature of the room and resin is between 72F-75F. Store in a safe, temperature-controlled environment and make sure caps are tightly sealed when not in use.

⦁ This epoxy resin and hardener system is a 1:1 mix ratio by volume. Please be sure to measure exact, using a measuring cup. It is recommended to mix a minimum of 2-3oz. at once.
⦁ Be sure to mix your resin and hardener in a round mixing container, and always pour the Resin into the Hardener. When they are fully combined, begin mixing slowly by hand in a circular fashion with a stirring device such as a wooden or silicone stick.
⦁ Mix thoroughly for approx. 3-5 minutes until the components are unified and clear. Take time to scrape the sides of the container and use the stirring device to go all the way to the bottom, helping to ensure everything is completely and consistently blended together. *Taking the time and effort to mix the resin and hardener is essential to make sure your application will cure properly.
⦁ After this, it is recommended to let components stand uninterrupted for approx. 3 minutes for optimum bubble release. At this point, a heating element or alcohol spray can be used if desired to help minimize any bubbles.
⦁ You are now ready to add in any resin colorants.
⦁ To help avoid your resin from overheating please begin to pour your resin onto your application directly after these steps.

After following these steps, please be sure to let your finished piece sit uninterrupted in a dust-free area, or, if applicable, place a protective covering over it (being sure not to touch it). The cure to touch time is 24 hours in ideal working environment, given instructions are followed correctly. After 72 hours, your finished product will be fully cured.
If you are sanding your cured resin, always be sure to work outside or in a well-ventilated area, and be sure to wear a mask, gloves, and goggles.
*Please note this resin is Non-Toxic and safe for incidental food contact when used as instructed and after a full 10-day cure cycle. This formula is Low VOC.